Alat Pendeteksi Asap Rokok Dengan Peringatan Suara Di Kawasan Bebas Asap Rokok Di Lingkungan Polman Babel

Authors

  • Haniza Haniza Politeknik Manufaktur Negeri Bangka Belitung
  • Berlian Pamungkas Politeknik Manufaktur Negeri Bangka Belitung
  • Zanu Saputra Politeknik Manufaktur Negeri Bangka Belitung
  • Novitasari Novitasari Politeknik Manufaktur Negeri Bangka Belitung

DOI:

https://doi.org/10.33504/manutech.v17i02.521

Keywords:

cigarette smoke, MQ-135 sensor, MQ-2 sensor, voice alert

Abstract

Polman Babel, which is one of the places for the nation's next generation to carry out the teaching and learning process in Bangka Regency, responds positively to regulations related to the No Smoking Area (KTR). This is realized by the presence of warning boards regarding the prohibition of smoking at several locations. The smoke-free area policy has been enforced, but there are still some violators and lack of awareness to comply with the regulation. To overcome this problem, a smoke detector is needed that can be used in the campus environment. A cigarette smoke detector using an MQ-135 sensor and an MQ-2 sensor that can emit a sound to encourage smokers to put out their cigarettes and leave the area was made. Detection tests were carried out with the distance of the sensor from the measured source of 1 meter to 3 meters and the calculation of the time from the appearance of smoke to the warning sound from the loudspeaker. The farther the sensor is from the smoke source, the smaller the detection value will be, depending on the position of the sensor and the smoke source. The sensor position that is accurate in detection is the sensor with the position facing down because it directly hits the smoke source. Like the nature of smoke that spreads from low places spreads towards the top.

Downloads

Download data is not yet available.

References

P. RI, “Salinan Peraturan Pemerintah Republik Indonesia Nomor 109 Tahun 2012 tentang Pengamanan Bahan yang Mengandung Zat Adiktif berupa Produk Tembakau Bagi Kesehatan,” 2012.

M. T. Bangka, “Salinan Peraturan Daerah Kabupaten Bangka Nomor 11 Tahun 2014 tentang Kawasan Tanpa Rokok (KTR),” pp. 1–20, 2014.

G. Farista and S. Sinta, “Implemetasi Kebijakan Kawasan Tanpa Rokok Di Bank Rakyat Indonesia Unit Toboli Parigi Kecamatan Parigi Utara,” SIBATIK J. J. Ilm. Bid. Sos. Ekon. Budaya, Teknol. dan Pendidik., vol. 1, no. 11, pp. 2421–2430, 2022, doi: 10.54443/sibatik.v1i11.363.

V. Nataya Kinanti, M. Yamin, and L. Fid Aksara, “Prototype Penyaring Asap Rokok Pada Smoking Area Menggunakan Pulse Width Modulation (Pwm) Dan Fuzzy Tsukamoto,” semanTIK, vol. 2, no. 1, pp. 195–202, 2018.

H. E. Sari and H. Priyono, “MENGGUNAKAN ARDUINO UNO DI TOILET SEKOLAH,” vol. 18, pp. 415–424, 2024.

D. N. Ilham, R. A. Candra, M. S. Talib, M. di Nardo, and K. Azima, “Design of Smoke Detector for Smart Room Based on Arduino Uno,” Brill. Res. Artif. Intell., vol. 1, no. 1, pp. 13–18, 2021, doi: 10.47709/brilliance.v1i1.1079.

M. S. Mauludin, A. Faisa, and D. D. W. l Alfalah, “Mq-2 sebagai sensor anti asap rokok berbasis arduino dan bahasa C,” J. Tek. dan Ilmu Komput., vol. 1, no. 1, pp. 260–265, 2016, doi: http://dx.doi.org/10.36499/psnst.v1i1.1545.

A. Aditya, A. Matien, D. Yunadi, and S. Susilawati, “Alat Pendeteksi Asap Rokok pada Ruangan Menggunakan Sensor MQ-2 dan Microcontroller Arduino Uno,” Syntax J. Inform., vol. 6, no. 1, pp. 37–46, 2017, doi: 10.35706/syji.v6i1.1151.

P. Mandarani and R. Ariani, “Perancangan Sistem Deteksi Asap Rokok Menggunakan Layanan Short Message Service (Sms) Alert Berbasis Arduino,” J. TEKNOIF, vol. 4, no. 2, pp. 66–75, 2016.

Rombang IA, Setyawan LB, & Dewantoro G.” Perancangan Prototipe Alat Deteksi Asap Rokok dengan Sistem PurifierMenggunakan Sensor MQ-135 dan MQ-2”. Techné Jurnal Ilmiah Elektroteknika Vol. 21 No. 1 April 2022 Hal 131 -144.

Downloads

Published

2025-12-30

How to Cite

Haniza, H., Pamungkas, B. ., Saputra, Z. ., & Novitasari, N. (2025). Alat Pendeteksi Asap Rokok Dengan Peringatan Suara Di Kawasan Bebas Asap Rokok Di Lingkungan Polman Babel. Manutech : Jurnal Teknologi Manufaktur, 17(02), 170–176. https://doi.org/10.33504/manutech.v17i02.521